公司新聞
冷再生機施工工藝與優勢的分析
來源：http://www.cansolv.cn/ 日期：2023-03-13
冷再生機是為適應城鄉道路建設而設計制造的具有環保、高能效的道路施工設備，作業時在對舊瀝青路面進行銑刨、破碎的同時，添加穩定劑（水泥、石灰、水等），就地拌和通過整形、壓實而形成新的道路基層。冷再生機租賃廠家為您講解下其優勢與工藝事項。
The cold recycling machine is a road construction equipment with environmental protection and high energy efficiency designed and manufactured to adapt to the construction of urban and rural roads. During the operation, while milling and crushing the old asphalt pavement, the stabilizer (cement, lime, water, etc.) is added, and the new road base is formed by local mixing, shaping and compaction. The cold regeneration machine rental manufacturer will explain its advantages and technological matters to you.
工藝
workmanship
1、對舊路結構狀況進行調查，并鋪筑試驗路，以確定需要再生的深度和新集料的添加量等工藝參數，長度不宜小于200米。
1. Investigate the structure of the old road and pave the test road to determine the depth of regeneration and the addition of new aggregate and other process parameters. The length should not be less than 200 meters.
2、冷再生施工前應將舊路路面清掃干凈，并將舊路明顯的沉陷、坑槽進行填平處理。
2. Before cold regeneration construction, the old road surface shall be cleaned and the obvious settlement and pit of the old road shall be filled and leveled.
3、人工或機械攤鋪添加劑（水泥、石灰、新集料等），按設計的添加量計算每平方米的添加量。
3. For manual or mechanical paving of additives (cement, lime, new aggregate, etc.), the amount added per square meter shall be calculated according to the designed amount.
4、冷再生機進行作業。施工過程中，應隨時檢查深度及速度，以保證再生深度及破碎的混合料級配合理。
4. The cold regenerator works. During construction, the depth and speed shall be checked at any time to ensure that the regeneration depth and the broken mixture gradation are reasonable.
5、使用推土機初找平，并均勻排壓，然后使用平地機刮平至設計高程。
5. Use a bulldozer for initial leveling, and discharge pressure evenly, and then use a grader to level to the design elevation.
6、檢測含水量，必要時補水，使其符合佳含水量，然后進行路面碾壓形成新的道路基層。
6. Check the water content, add water if necessary to make it conform to the optimum water content, and then roll the pavement to form a new road base.
7、道路基層養生。養生時間不少于7天，養生期間進行交通管制。
7. Road base curing. The curing time shall not be less than 7 days, and traffic control shall be conducted during the curing period.
8、鋪筑面層，壓實形成新的路面。
8. Pave the surface layer and compact it to form a new pavement.
優勢
advantage
（1）成本低
(1) Low cost
（2）提高舊路等級
(2) Improve the grade of old roads
（3）不損壞路基
(3) No damage to subgrade
（4）可以不中斷交通
(4) Traffic can be uninterrupted
（5）工期短
(5) Short construction period
（6）保護環境和資源
(6) Protect the environment and resources
冷再生機施工工藝與優勢的分析就到這里了，建議您在使用前要對其進行充足的了解，使用過程中做好預防措施，使用之后要及時進行機器的清理，更多注意事項就來我們網站http://www.cansolv.cn咨詢！
This is the end of the analysis of the construction process and advantages of the cold recycling machine. It is recommended that you fully understand it before use, take preventive measures during use, and clean the machine in time after use. For more precautions, please visit our website http://www.cansolv.cn consulting service
公司地址：濟南市槐蔭區經一路273號群盛華城2號樓1-404
公司名稱：山東途暢路橋工程有限公司 
備案號：